Cutting
of pipe.
For
a quick and precise cut,a pipe cutter with a long
blade is recommended.
Shears should not be used in that they risk ovalizing
the pipe.(picture A) |
 |
| |
|
Sizing
and beveling of pipe.
This
step must be carried out before fitting the insert
into the pipe.
Insert the sizing pin into the pipe,turning it carefully
until a perfectly round circumference has been obtained.
After the pipe has been sized,the same instrument
is used to bevel the end of the pipe;this is to
facilitate entrance of the insert.The sizing pin
has been developed with a miller at the bottom of
the pin so that the same instrument is used both
for sizing and beveling;make sure to remove the
resulting shavings.(picture B) |
 |
| |
|
Positioning
of sleeve.
In
order to be sure that the insert is pushed correctly
into the pipe follow these instructions:
1.remove the sleeve from the fitting without moving
the white seat(picture C)and place it over the pipe
2.place the sleeve over the pipe and mark as shown
in picture D. |
 |
| |
|
Connection.
1.Remove
the sleeve from the pipe.
2.Lubricate the inside of the pipe and the insert
and extends the life of the O-Rings.
3.Slide the sleeve over the insert.
4.Insert the pipe between the insert and the sleeve
(picture D) |
 |
| |
|
Pressing.
Place
the jaws over the sleeve and align them with the
white seal and crimp. |
 |
| |
|
